Bangle Size Guide

Measure an existing bangle or measure the hand where the bangle needs to pass over it.

Method 1: Measure a Bangle That Already Fits

Choose a bangle that fits the intended wearer well.
Lay it flat on a hard surface.
Measure the inside diameter straight across the centre from inner edge to inner edge.
Record the measurement in millimetres and compare it with the reference table below.

Method 2: Measure the Hand

Bring the thumb towards the little finger as you would when putting on a bangle.
Use a flexible tape around the widest part of the hand that the bangle needs to pass over.
Keep the tape close to the hand without pulling it tight.
Repeat the measurement and compare it with an existing bangle where possible.

Traditional Bangle Size Reference

Bangle Size (Soot)	Traditional Size	Inside Diameter (mm)
2"	2"	50.8
2" 1/2 soot	2-1	52.39
2" 1 soot	2-2	53.98
2" 1 1/2 soot	2-3	55.56
2" 2 soot	2-4	57.15
2" 2 1/2 soot	2-5	58.74
2" 3 soot	2-6	60.33
2" 3 1/2 soot	2-7	61.91
2" 4 soot	2-8	63.5
2" 4 1/2 soot	2-9	65.09
2" 5 soot	2-10	66.68
2" 5 1/2 soot	2-11	68.26
2" 6 soot	2-12	69.85
2" 6 1/2 soot	2-13	71.44
2" 7 soot	2-14	73.03
2" 7 1/2 soot	2-15	74.61
3"	3"	76.2

Reference only

The table converts traditional bangle notation into approximate inside diameter. It does not mean every size is available for every Gold Factory product. Always check the size options shown for the individual item.

Choosing the Fit

The bangle must fit the intended wearer and, where it needs to pass over the hand, must clear the widest part of the hand without excessive force.
Bangle width and shape can change how the same inside diameter feels.
Use the measurements and sizing information shown for the individual product, because construction can affect the practical fit.
If you are between measurements or unsure, contact Gold Factory before ordering.

Visit Gold Factory

Monday to Saturday: 11:00 am to 6:30 pm. Sunday closed.